No replies
dewateringscreen's picture
Last seen: 11 years 8 weeks ago
Timezone: GMT+8
Joined: 2012-03-06
Posts: 1
Points: 2

As we everyone knows,in the useing progress of vibrating screen ,it's necessary to maintain the vibrating screen.Then what's the vibrating screen maintenance,how will the vibrating screen have a long life?Here,we LIPU Heavy Industry's engineers will give you some tips for vibrating screen maintenance:

1.When disassemble the surface of precision parts, should be especially careful to protect these parts of surface to avoid damage.

2.Open the machine parts of surface which would be rust and intend to be stored outside of machine more than a few hours, must be well protected and coated with oil,or coated with rust inhibitor.

3.Disassemble the machine parts with bearing surface and machined surface, should lay a wooden plate on the ground to prevent a direct contact between precision work surface and ground.

4.Before equipping parts on screening machine, should be cleaning and oiling in advance.

5.Percussion of hammer direct to parts is not allowed when loading and unloading process,there must be copper stick or other pad between hammer and parts. Should be special attention to the damage and cracks of casting parts because of percussion.Sometimes the cracks of these parts would exist after operation heating only.

6.When the bearing is damaged,it is best to replace two of bearing at the same time.If due to limited condition,can not replace both two of bearing,should disassemble all the bearing ,clean them and then do the installation.

7.When install a new vibrating screen mesh,must make the connection between screen mesh and screen box angle steel or groove steel firmed,and tighten them.

The above are the suggestions to the maintain of vibrating screen for mining use.If you have other questions about the mining screens,such as the circular vibrating screen,high frequency screen etc,please don't hesitate to contact us,you will get satisfied answers.